The following is an overview of the user manual for the Z-Wave product External siren (SR-BX-ZW)from Yale. To view other Z-Wave products and manuals from Yale follow that link.
Overview
Security
As a Z-Wave Plus certified product, External siren supports Z-Wave S2 security. The following security modes are directly supported:
Features
Yale describes External siren as having the following features:
- Battery Quantity
- Battery powered using D size batteries
- Firmware updatable via a compatible Z-Wave gateway
- IP (Ingress Protection) Rated
- Outdoor Use
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
REMOVING THE SIREN
The Siren must be removed from any existing Z-Wave network before being added into a new Z-Wave network. There are two methods available to remove a device.
Removing Mode
• Put the existing Z-Wave controller into Removing Mode (please refer to the Z-Wave controller manual).
• Within 1.5 seconds, press the learn button 3 times and the Siren will be removed from the existing Z-Wave network.
• The Siren is now ready to be added to a new Z-Wave controller.
Factory reset External siren
Factory Reset (Only use this when the existing Z-Wave controller is missing or inoperable).
• Turn off battery power switch and disconnect 9V power adaptor (if present).
• Press and hold the learn button.
• While holding the learn button, power on the Siren (power switch ON and reconnect the 9V power adaptor). Keep holding for 10 seconds to complete the factory reset.
• Please note that the existing Z-Wave controller will still retain the Siren’s Z-Wave setting. Please refer to the Z-Wave controller manual on remove procedures. Only use this when the existing Z-Wave controller is missing or inoperable.
• The Siren is now ready to be added to a new Z-Wave controller.
ADDING THE SIREN
This product can be added and operate in any compatible Z-Wave network. All non-battery operated nodes within the network will act as repeaters, regardless of vendor, to increase reliability of the network.
Adding steps:
• Turn on the battery power switch to activate
the pre-inserted batteries.
• The Siren will emit a 2-tone beep.
• Put the Z-Wave controller into adding or
Learning mode (please refer to the Z-Wave
controller manual).
• Within 1.5 seconds, press the Siren learn button
3 times.
• Refer to the operation manual of the Z-Wave
controller to complete the learn-in process.
• If the Siren has already been added (learnt) into
another Z-Wave controller, or if the Siren is unable
to be learnt into the current Z-Wave controller,
please remove it first (see Removing the siren below)
before attempting to add it into the current
Z-Wave controller.
Please note that this is a user manual External siren from Yale is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have External siren and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.