NexTouch Keypad Exit Rim Trim (NTT610-ZW2) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product NexTouch Keypad Exit Rim Trim (NTT610-ZW2)from Yale Locks & Hardware. To view other Z-Wave products and manuals from Yale follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Yale NexTouch Keypad Exit Rim Trim
SKU Code
NTT610-ZW2
Description
Yale nexTouch electrified trim for Yale and competitor rim exit devices with Push Button keypad and supporting modular radio technology
Version #
HW: 255 FW: 1.78:25.00 was the version certified
Certification #
ZC10-19066561
Certified
2019-06-25T20:27:35.801232
Z-Wave Version
6.51.07

Security

As a Z-Wave Plus certified product, NexTouch Keypad Exit Rim Trim supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Yale describes NexTouch Keypad Exit Rim Trim as having the following features:

    • Door Lock Type
    • Firmware updatable via a compatible Z-Wave gateway
    • IP (Ingress Protection) Rated
    • Outdoor Use
    • Battery Quantity
    • Sensors
    • Supported Notification Types
    • Battery powered using AA batteries
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Enter the 4-8 master Pin code followed by the gear key.
    Press the 7 key followed by the gear key
    Press the 1 key followed by the gear key

    Enter the 4-8 digit master pin code followed by the gear key
    Press the 7 key followed by the gear key
    Press the 3 key followed by the gear key

    Factory reset NexTouch Keypad Exit Rim Trim

    Remove the battery cover and batteries.
    Remove the interior escutcheon to access the reset button.
    The reset button is located above the PCB cable connector.
    While pressing the reset button for a minimum of 3 seconds, reinstall batteries. Release reset button.
    Replace battery cover.
    Please use this procedure only when the network primary controller is missing or otherwise inoperable

    Please note that this is a user manual NexTouch Keypad Exit Rim Trim from Yale Locks & Hardware is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have NexTouch Keypad Exit Rim Trim and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.