The following is an overview of the user manual for the Z-Wave product nexTouch Sectional Mortise Push Button Keypad Lock with no cylinder, no deadbolt (NTM630-ZW2)from Yale Locks & Hardware. To view other Z-Wave products and manuals from Yale follow that link.
Overview
Security
As a Z-Wave Plus certified product, nexTouch Sectional Mortise Push Button Keypad Lock with no cylinder, no deadbolt supports Z-Wave S2 security. The following security modes are directly supported:
Features
Yale describes nexTouch Sectional Mortise Push Button Keypad Lock with no cylinder, no deadbolt as having the following features:
- Outdoor Use
- Battery powered using AA batteries
- Door Lock Type
- IP (Ingress Protection) Rated
- Battery Quantity
- Firmware updatable via a compatible Z-Wave gateway
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Press any button on the keypad to wake
1. Enter the 4-8 digit master PIN code followed by the gear key.
2. Press the 7 key followed by the gear key.
3. Press the 1 key followed by the gear key.
1. Enter the 4-8 digit master PIN code followed by the gear key.
2. Press the 7 key followed by the gear key.
3. Press the 3 key followed by the gear key.
Factory reset nexTouch Sectional Mortise Push Button Keypad Lock with no cylinder, no deadbolt
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
1. Remove the inside lever with the lever removal tool.
2. Remove battery cover using hex wrench provided with lock.
3. Remove four (4) AA batteries.
4. Remove the 10-32 x 3/4"" pan head screw from the center of the battery housing into the barrel nut of the outside assembly.
5. Remove inside escutcheon. Cables may stay connected.
6. Reinstall batteries
7. On the back of the PC board, push and hold the Reset Button with the lever removal tool for 3 seconds.
8. While continuing the press the reset button, temporarily remove one AA battery.
9. Reinstall the battery
10. Release reset button and wait 15 seconds. Speaker will announce ""Welcome to Yale""
11. Reassemble escutcheon
Please note that this is a user manual nexTouch Sectional Mortise Push Button Keypad Lock with no cylinder, no deadbolt from Yale Locks & Hardware is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have nexTouch Sectional Mortise Push Button Keypad Lock with no cylinder, no deadbolt and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.