The following is an overview of the user manual for the Z-Wave product Real Living Assure Lock Interconnected Z-Wave Enabled Touch Screen Deadbolt (YRC226-ZW3)from Yale. To view other Z-Wave products and manuals from Yale follow that link.
Overview
Security
As a Z-Wave Plus certified product, Real Living Assure Lock Interconnected Z-Wave Enabled Touch Screen Deadbolt supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
Features
Yale describes Real Living Assure Lock Interconnected Z-Wave Enabled Touch Screen Deadbolt as having the following features:
- Color
- Communications Connections
- Communications Protocol
- Battery Quantity
- Controller Supports Multiple Z-Wave Interfaces
- Door Lock Type
- Firmware updatable via a compatible Z-Wave gateway
- Battery powered using AA batteries
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Open Z-Wave system's smart home or alarm app and follow instructions for removing a device
2. On your lock keypad, enter your master entry code followed by the icon
3. Press the 7 key followed by the gear icon
4. Press the 3 key followed by the gear icon
Press Yale logo to wake up lock
Factory reset Real Living Assure Lock Interconnected Z-Wave Enabled Touch Screen Deadbolt
Remove the battery cover and batteries.
Remove the interior escutcheon to access the reset button.
The reset button is located above the PCB cable connector.
While pressing the reset button for a minimum of 3 seconds, reinstall batteries. Release reset button.
Replace battery cover.
Please use this procedure only when the network primary controller is missing or otherwise inoperable
Paragraph 8. Compability/ Principles for regulation. Water based heating - Electrical heating.
Paragraph 9. Information shown in display. The main screen - Secondary screen - Connecting to an external relay.
Paragraph 10. Hysteresis.
Paragraph 11. Child lock.
Paragraph 12. Standby and main screen.
SmartStart location
SmartStart QR code's location as follows: Sticker on module and insert
Install Yale Smart Module into slot above battery compartment
IMPORTANT: Batteries must be removed before inserting Yale Smart Module:
• Remove battery cover
• Remove batteries
• Insert Yale Smart Module
• Reinstall batteries
• Reinstall battery cover
2. Open Z-Wave system's smart home or alarm app on your smartphone or tablet
3. If you have Smart Start* enabled with your Z-Wave System follow in-app prompts to add a new device
If you don't have smart start or are not sure, follow steps 4 - 6
4. On your lock keypad, enter your master entry code followed by the gear icon
5. Press the 7 key followed by the gear icon
6. Press the 1 key followed by the gear icon
Please note that this is a user manual Real Living Assure Lock Interconnected Z-Wave Enabled Touch Screen Deadbolt from Yale is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Real Living Assure Lock Interconnected Z-Wave Enabled Touch Screen Deadbolt and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.