The following is an overview of the user manual for the Z-Wave product YRD156 Touchscreen Deadbolt with Integrated ZWave Plus (YRD156-ZW2)from Yale Locks & Hardware. To view other Z-Wave products and manuals from Yale follow that link.
Overview
Security
As a Z-Wave Plus certified product, YRD156 Touchscreen Deadbolt with Integrated ZWave Plus supports Z-Wave S2 security. The following security modes are directly supported:
Features
Yale describes YRD156 Touchscreen Deadbolt with Integrated ZWave Plus as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Outdoor Use
- Supported Notification Types
- Battery powered using AA batteries
- Battery Quantity
- Door Lock Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Enter the 4-8 digit master PIN code followed by the gear key.
2. Press the 7 key followed by the gear key.
3. Press the 1 key followed by the gear key.
1. Enter the 4-8 digit master PIN code followed by the gear key.
2. Press the 7 key followed by the gear key.
3. Press the 3 key followed by the gear key.
Factory reset YRD156 Touchscreen Deadbolt with Integrated ZWave Plus
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
1. Remove the inside lever with the lever removal tool.
2. Remove battery cover using hex wrench provided with lock.
3. Remove four (4) AA batteries.
4. Remove the 10-32 x 3/4"" pan head screw from the center of the battery housing into the barrel nut of the outside assembly.
5. Remove inside escutcheon. Cables may stay connected.
6. Reinstall batteries
7. On the back of the PC board, push and hold the Reset Button with the lever removal tool for 3 seconds.
8. While continuing the press the reset button, temporarily remove one AA battery.
9. Reinstall the battery
10. Release reset button and wait 15 seconds. Speaker will announce ""Welcome to Yale""
11. Reassemble escutcheon
Please note that this is a user manual YRD156 Touchscreen Deadbolt with Integrated ZWave Plus from Yale Locks & Hardware is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have YRD156 Touchscreen Deadbolt with Integrated ZWave Plus and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.