The following is an overview of the user manual for the Z-Wave product Z-Wave Enabled Keyless Deadbolt (YRD642-ZW2)from Yale Locks & Hardware. To view other Z-Wave products and manuals from Yale follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Wave Enabled Keyless Deadbolt supports Z-Wave S2 security. The following security modes are directly supported:
Features
Yale describes Z-Wave Enabled Keyless Deadbolt as having the following features:
- Battery Quantity
- Battery powered using batteries
- Door Lock Type
- Firmware updatable via a compatible Z-Wave gateway
- IP (Ingress Protection) Rated
- Outdoor Use
- Sensors
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Enter the 4-8 master Pin code followed by the gear key.
Press the 7 key followed by the gear key
Press the 1 key followed by the gear key
Enter the 4-8 digit master pin code followed by the gear key
Press the 7 key followed by the gear key
Press the 3 key followed by the gear key
Press the Yale logo to wake the lock.
You will be guided through setup by
audio instructions on the lock.
Additional entry codes and further
programming can be done through
the Settings Menu. Refer to page 19
for YRD226 or page 20 for
YRD620/YRD622.
Factory reset Z-Wave Enabled Keyless Deadbolt
Remove the battery cover and batteries.
Remove the interior escutcheon to access the reset button.
The reset button is located above the PCB cable connector.
While pressing the reset button for a minimum of 3 seconds, reinstall batteries. Release reset button.
Replace battery cover.
Please use this procedure only when the network primary controller is missing or otherwise inoperable
Please note that this is a user manual Z-Wave Enabled Keyless Deadbolt from Yale Locks & Hardware is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Enabled Keyless Deadbolt and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.