Smart Ashley+Z (YDL110DZ) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Smart Ashley+Z (YDL110DZ)from Yasuda Co,. Ltd. To view other Z-Wave products and manuals from Yasuda follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Smart Ashley+Z
SKU Code
YDL110DZ
Description
YDL110DZ Smart Lock is a device that can control the door lock and check the status from outside as well as near by using Bluetooth or Gateway.
In addition, this product can communicate with Z-Wave Plus products in compliance with the Z-Wave Plus communication security standard.
Version #
HW: 255 FW: 4.01:04.02 was the version certified
Certification #
ZC10-19016365
Certified
2019-01-30T21:26:44.903641
Z-Wave Version
6.81.01

Security

As a Z-Wave Plus certified product, Smart Ashley+Z supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Access Control

Features

Yasuda describes Smart Ashley+Z as having the following features:

  • IP (Ingress Protection) Rated
  • Outdoor Use
  • Battery Quantity
  • Battery powered using CR123A batteries
  • Gateway Has Preferred Partners
  • Door Lock Type
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

Exclusion:
1. Insert the battery.
2. The handle is unhooked.
3. Press and hold the 'B' Tact switch for about 3 seconds.
4. (If door lock is in inclusion) Door lock enters exclusion mode.

Inclusion:
1. Insert the battery.
2. The handle is unhooked.
3. Press and hold the 'B' Tact switch for about 3 seconds.
4. Door lock enters Inclusion Mode.

Factory reset Smart Ashley+Z

1. Insert the battery.
2. The handle is unhooked.
3. Press and hold the 'A' + 'B' Tact switch for about 5 seconds.
4. Door lock is factory reset.
* Please use this procedure only when the network primary controller is missing or otherwise inoperable.

1. To lock / unlock the handle by manually moving it.
2. Receiving Z-Wave Command.

Please note that this is a user manual Smart Ashley+Z from Yasuda Co,. Ltd is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Ashley+Z and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.