Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Wall Switch (ZHC5010) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Wall Switch (ZHC5010)from Z-Home Control. To view other Z-Wave products and manuals from Z-Home Control follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Wall Switch
SKU Code
ZHC5010
Description
ZHC5010 is a wall switch module with four buttons, four LEDs, a built-in relay switch and is designed to fit into standard Danish LK FUGA® wall boxes.
Version #
HW: 1 FW: 1.00 was the version certified
Certification #
ZC10-16055065
Certified
2016-05-09T12:08:40.9334
Z-Wave Version
6.61.00

Security

As a Z-Wave Plus certified product, Wall Switch supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Z-Home Control describes Wall Switch as having the following features:

    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Pushing the upper left button 3 times, (triple click) will activate Exclusion Mode on the device. It is also possible to activate Exclusion Mode by triple clicking the switch in the middle of the module (normally covered by the middle plastic cover, this can be removed by means of a little screwdriver).

    Factory reset Wall Switch

    ZHC5010 can be factory reset by pressing the small button in the middle of the module (normally covered by small plastic cover) for at least 10 seconds. Please use this procedure only when the network primary controller is missing or otherwise inoperable.

    Pushing the upper left button 3 times, (triple click) will activate Inclusion Mode on the device. It is also possible to activate Inclusion Mode by triple clicking the switch in the middle of the module (normally covered by the middle plastic cover, this can be removed by means of a little screwdriver).

    Please note that this is a user manual Wall Switch from Z-Home Control is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Wall Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.