The following is an overview of the user manual for the Z-Wave product Certified Installer Toolkit (ZWEUCIT1)from Z-Wave Alliance. To view other Z-Wave products and manuals from Z-Wave Alliance follow that link.
Overview
The tool includes the ability to query devices to learn about them, to show routing and neighbor information, measure link quality, show and track noise, and even display application layer messages that are heard by the CIT (Z-Wave Network Sniffer = zNiffer)
Security
As a Z-Wave Plus certified product, Certified Installer Toolkit supports Z-Wave S2 security. The following security modes are directly supported:
Features
Z-Wave Alliance describes Certified Installer Toolkit as having the following features:
- Color
- Communications Connections
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Place the network controller into exclusion mode by following the manufacturer's instructions, then in the CIT user interface, on the home page, click ""Leave Network""
Place the network controller into inclusion mode by following the manufacturer's instructions, then in the CIT user interface, on the home page, click ""Join Network""
Factory reset Certified Installer Toolkit
If the CIT is the primary controller for a network (not recommended) following this procedure will result in nodes being orphaned (no controller). If the CIT is a part of a network, following this procedure will leave an invalid node in the list for the primary controller. Therefore, under these two conditions above, use this procedure only if the network primary controller is missing or is otherwise inoperable.
In the CIT user interface, click the menu item Network, then Control, and then on the control page click ""Controller Factory Default"".
Place the network controller into learn mode by following the manufacturer's instructions, then in the CIT user interface, on the home page, click ""Join Network""
Please note that this is a user manual Certified Installer Toolkit from Z-Wave Alliance is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Certified Installer Toolkit and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.