Outdoor Siren (005107) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Outdoor Siren (005107)from Z-Wave.Me. To view other Z-Wave products and manuals from Z-Wave.Me follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


Outdoor Siren
SKU Code
This device is a siren for Z-Wave security systems. Due to its large solar panel it can be used without any additional power supply or batteries. The siren can be installed on any place on the outside of the house and can be controlled using Z-Wave. This way it extends security systems and calls attention in case of a triggered alarm.
The siren issues a very loud sound (105 dBm) and in parallel some stroboscope light.
Furthermore the device is self-protecting. Removing the main device from the mounting unit immediately starts the siren and also reports the tamper attempt to the Z-Wave control center. All communication between the Z-Wave controller and the siren is encrypted and secured to protect against manipulation.
Version #
HW: 1 FW: 1.01 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, Outdoor Siren supports Z-Wave S2 security. The following security modes are directly supported:


    Z-Wave.Me describes Outdoor Siren as having the following features:

    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Open the case and turn on the power switch
    2. Remove the metal mounting plate from the device.
    3. Turn your controller into inclusion mode with a short single click on the internal inclusion button.

    Make sure the device is unarmed. Then turn the controller into exclusion mode, open the device and hit the inclusion button once. This removes the device from the network.

    Factory reset Outdoor Siren

    To reset the device keep the inclusion button pushed for 10 seconds. After 5 seconds the LED starts flashing and after another 5 seconds there is a short beep signaling the successful reset back to factory defaults. Use this procedure only when the network primary controller is missing or otherwise inoperable.

    Please note that this is a user manual Outdoor Siren from Z-Wave.Me is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Outdoor Siren and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.