The following is an overview of the user manual for the Z-Wave product RaZberry 7 Pro - Z-Wave Shield for Raspberry Pi (ZME_RAZBERRY7_ANT)from Z-Wave.Me. To view other Z-Wave products and manuals from Z-Wave.Me follow that link.
As a Z-Wave Plus certified product, RaZberry 7 Pro - Z-Wave Shield for Raspberry Pi supports Z-Wave S2 security. The following security modes are directly supported:
Z-Wave.Me describes RaZberry 7 Pro - Z-Wave Shield for Raspberry Pi as having the following features:
- Communications Connections
- Communications Protocol
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Factory reset RaZberry 7 Pro - Z-Wave Shield for Raspberry Pi
Z-Wave Serial API SetDefault command is used to reset the RaZberry7 board to factory default settings.
If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual RaZberry 7 Pro - Z-Wave Shield for Raspberry Pi from Z-Wave.Me is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have RaZberry 7 Pro - Z-Wave Shield for Raspberry Pi and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.