The following is an overview of the user manual for the Z-Wave product Secure Key Chain Controller (ZME_KFOBC)from Z-Wave.Me. To view other Z-Wave products and manuals from Z-Wave.Me follow that link.
Overview
The controller also allows triggering scenes in a central controller. Again different modes can be configured to adapt to the various implementations of scenes in different central controllers in the market.
Control options also include special modes like 'all on/off' or always controlling the Z-Wave device in proximity to the fob. The device supports secure communication when included with enhanced security option and when communicating to a device also supporting enhanced security option. Otherwise the device will automatically turn into normal communication. to maintain backward compatibility.
Security
As a Z-Wave Plus certified product, Secure Key Chain Controller supports Z-Wave S2 security. The following security modes are directly supported:
Features
Z-Wave.Me describes Secure Key Chain Controller as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Enter management mode by push all four buttons together for one second - green led blinks slowly), hit button 3 ( enter primary controller functions - green led blinks faster) and then button 3 again.
When in factory default push Button 3 (secure) or Button 4 (normal) for one second to enter inclusion mode. The inclusion mode is indicated by a blinking green LED. From second device on you need to enter management mode push all four buttons together for one second - green led blinks slowly), hit button 3 ( enter primary controller functions - green led blinks faster) and then button 1 (secure) or button 2 (normal).
Enter management mode by push all four buttons together for one second - green led blinks slowly), then hit button 2 .
When in factory default push Button 1 (secure) or Button 2 (normal) for one second to enter learn mode. The learn mode is indicated by a blinking LEDs red/green. Learn mode will only activate when device is in factory reset state.
Factory reset Secure Key Chain Controller
Enter management mode by push all four buttons together for one second - green led blinks slowly), then hit button 3 followed by keeping button 4 pushed down for 10 seconds. The first five seconds the green LED still blinks followed by a long red, shot green sequence. Once LEDs go off, reset was executed. Please use this
procedure only if the device is secondary controller and the primary controller is missing or otherwise inoperable.
Please note that this is a user manual Secure Key Chain Controller from Z-Wave.Me is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Secure Key Chain Controller and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.