The following is an overview of the user manual for the Z-Wave product Smoke Detector and Siren (004001)from Z-Wave.Me. To view other Z-Wave products and manuals from Z-Wave.Me follow that link.
Overview
The Smoke detector will also work as a stand alone product and is certified by VDS according to EN 14604. The
smoke chamber of the detector has a stainless steel reel with antistatic plastic chamber.
A button allows on-device test of smoke chamber, electronics and battery. The device also offers a built-in self test and
an electronic smoke chamber test to avoid the use of test aerosol. A low battery warning will last for 30 days but full
function of the detector is guaranteed during this time.
The Z-Wave module allows to report the smoke and low battery alarm wirelessly to a central controller. The detector can
also be used as a wireless siren for alarm system or other applications. The wireless module is operated by the 9V battery
of the smoke detector. An optional external power supply allows external powering the unit.
According to VdS 3515 (Smoke Detectors with Wireless Communication) this device will send alarm signals to all other
smoke detectors registered in association group 2 to turn on their siren. This function ensures that all smoke detectors
will issue noise if one of them detected a smoke.
Security
As a Z-Wave Plus certified product, Smoke Detector and Siren supports Z-Wave S2 security. The following security modes are directly supported:
Features
Z-Wave.Me describes Smoke Detector and Siren as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Hit the little button on the wireless module for 1 second
Hit the little button on the wireless module for 1 second
Factory reset Smoke Detector and Siren
To reset the device keep the button pushed for 10 seconds. After 5 seconds the led starts flashing and after another 5
seconds there is a short beep signaling the successful reset back to factory defaults. Use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Smoke Detector and Siren from Z-Wave.Me is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smoke Detector and Siren and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.