The following is an overview of the user manual for the Z-Wave product Z-Uno G2 (Z-Uno G2)from Z-Uno by Z-Wave.Me. To view other Z-Wave products and manuals from Z-Wave.Me follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Uno G2 supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Z-Wave.Me describes Z-Uno G2 as having the following features:
- Communications Protocol
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Z-Uno supports SmartStart technology. You are able to add device to network by means of special QR-code/SmartStart string. Just plug in ZUno to power supply and scan SmartStart label, no other interruction with device is needed.
User is able to get SmartStart string using zme_make utility manually or by means of ArduinoIDE. You have to select "verbose output" in preferences of IDE. Smart Strart QR-code is listed in "Z-Uno board information" section.
Manually you are able to do it using the command: zme_make boardInfo -q -d
Please note that this is a user manual Z-Uno G2 from Z-Uno by Z-Wave.Me is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Uno G2 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.