Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Z-Uno (v3) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Z-Uno (v3)from Z-Wave.Me. To view other Z-Wave products and manuals from Z-Wave.Me follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Z-Uno
SKU Code
v3
Description
Z-Uno is the first and only easy to use developer board that allows you to create your own Z-Wave device without deep knowledge of Z-Wave protocol or programming. Z-Uno is a mix of Z-Wave home automation radio protocol power and Arduino simplicity. Being inspired by Arduino project Z-Uno inherits all concepts of easy-to-use hardware and software solutions, keeping maximum flexibility.

Z-Uno is a fully DIY product. It is made for those who are limited by existing choice of Z-Wave products and wants to extend their smart homes with more sensors and actuators: connect LEDs, buttons, switches, motors or any low voltage sensor including most of Arduino compatible sensors.

Z-Uno programming is done by writing sketch in simplified C language and loaded into Z-Uno using Arduino IDE. Many examples and comprehensive tutorials will help you to make your own project.

This is one of the two officially certified sketches.

Certified 10 Channels sketch
http://z-uno.z-wave.me/examples/Certified10Channels/
Version #
HW: 1 FW: 0.70 was the version certified
Certification #
ZC10-16065104
Certified
2016-06-08T13:54:25.4
Z-Wave Version
6.51.06

Security

As a Z-Wave Plus certified product, Z-Uno supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Z-Wave.Me describes Z-Uno as having the following features:

    • Communications Connections
    • Firmware updatable via a compatible Z-Wave gateway
    • Sensors
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Press Service button three times

    Press Service button three times

    Factory reset Z-Uno

    Hold Service button for five seconds, then press Service button three times.

    Use this procedure only if your controller is missing or inoperable.

    Note that the user sketch is not erased during exclusion or reset process.

    Press Service button three times

    Please note that this is a user manual Z-Uno from Z-Wave.Me is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Uno and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.