The following is an overview of the user manual for the Z-Wave product Z-Wave CO Detector (004407)from Z-Wave.Me. To view other Z-Wave products and manuals from Z-Wave.Me follow that link.
Overview
1. Alarm on Sensing Carbon Monoxide
2. Battery status reporting
3. Sensor Fault
4. Alarm removal from mounting plate
5. End of life to make sure it is replaced on time.
The device is a secure Z-Wave Plus device and can be used in one wireless Z-Wave network with other certified devices regardless of origin and brand.
Security
As a Z-Wave Plus certified product, Z-Wave CO Detector supports Z-Wave S2 security. The following security modes are directly supported:
Features
Z-Wave.Me describes Z-Wave CO Detector as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
A single click on the button will exclude the device.
Factory reset Z-Wave CO Detector
To do a factory reset press the button on the bottom of the device for at least 10 seconds. This procedure should only be used when the primary controller is inoperable.
A single click on the button will wakeup the device.
Pressing the button 'Inclusion Button' for one second will include the device. If the button is pressed for at least 2 seconds the inclusion will be done without the Security Command Class.
Please note that this is a user manual Z-Wave CO Detector from Z-Wave.Me is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave CO Detector and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.