The following is an overview of the user manual for the Z-Wave product 3G Gateway (ZG-501-v1)from Z-Works. To view other Z-Wave products and manuals from Z-Works follow that link.
Overview
Security
As a Z-Wave Plus certified product, 3G Gateway supports Z-Wave S2 security. The following security modes are directly supported:
Features
Z-Works describes 3G Gateway as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Gateway Has Preferred Partners
- Color
- Controller Supports Multiple Networks
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To remove a device from the Z-Wave network, hold down the hardware button of this equipment (between 3 and 9 seconds). This will put the equipment into Exclusion mode and Z-Wave LED blinks quickly (once every 200 ms)
Factory reset 3G Gateway
Hold down the hardware button (over 10 seconds). This will reset the Z-Wave chip and Z-Wave LED blinks 5 times quickly. Upon reset, the hardware will broadcast the “DEVICE RESET LOCALLY NOTIFICATION”. Reset cannot be aborted.
If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
To add a device to the Z-Wave network, press the hardware button of this equipment three times in quick (no more than 1 second between). This will put this equipment into Inclusion mode and Z-Wave LED blinks slowly (once every second). The hardware will stay in Inclusion mode for 1 minute.
To add this equipment into another Z-Wave network as a secondary controller or inclusion controller, click “Start Learn Mode” in the GUI provided.
Please note that this is a user manual 3G Gateway from Z-Works is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have 3G Gateway and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.