The following is an overview of the user manual for the Z-Wave product Heart Beat Sensor (ZH-500-v1)from Z-Works. To view other Z-Wave products and manuals from Z-Works follow that link.
Overview
Security
As a Z-Wave Plus certified product, Heart Beat Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Z-Works describes Heart Beat Sensor as having the following features:
- Sensors
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Push A (Add/Remove/Reset) button once.
Push A (Add/Remove/Reset) button once.
Factory reset Heart Beat Sensor
Press A (Add/Remove/Reset) button for at least 10 seconds and release. The Vital Sensor will send the “Device Reset Locally” command and reset all settings to the factory default. Reset cannot be aborted. Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Heart Beat Sensor from Z-Works is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Heart Beat Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.