Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

LiveConnect Center (ZG-500-v1) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product LiveConnect Center (ZG-500-v1)from Z-Works. To view other Z-Wave products and manuals from Z-Works follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
LiveConnect Center
SKU Code
ZG-500-v1
Description
Gateway that can be adopted in low price for Smart Home / Smart Facility where broadband is available.　Using the sensors provided by Z-Works together with the gateway, the sensor data can be sent to the cloud server where the data is translated to human action and/or status. In the daily life or work scene, a user can receive notification from the cloud server based on the scenario registered in advance.
Version #
HW: 1 FW: 4.26:01.05 was the version certified
Certification #
ZC10-16045058
Certified
2016-03-16T09:39:01.3808
Z-Wave Version
6.51.03

Security

As a Z-Wave Plus certified product, LiveConnect Center supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Z-Works describes LiveConnect Center as having the following features:

    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    The exclusion can be done through the hardware button. A long single click (between 3 and 9 seconds) will trigger the exclusion. A button on the GUI is also present to start the exclusion (""Start Exclusion"" button). The Gateway will wait for a device to be excluded for 60 seconds.

    The inclusion can be done through the hardware button. Triple quick click on the button will trigger the inclusion. A button on the GUI is also present to start the inclusion (""NWI"" or ""ADD"" button). The Gateway will wait for a device to be included for 60 seconds.

    The learn mode can be done only through a provided GUI. The Gateway will try to include itself into an existing Z-Wave network. No hardware button can trigger this mode.

    Factory reset LiveConnect Center

    The reset can be done through the hardware button. A long single click (over 10 seconds) will trigger the reset. A button on the GUI is also present to start the reset (""Resets the Chip"").
    Please use this procedure only when the network primary controller is missing or otherwise inoperable.

    Please note that this is a user manual LiveConnect Center from Z-Works is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have LiveConnect Center and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.