The following is an overview of the user manual for the Z-Wave product Lock Dectector (DN3G6JA062)from Z-Works. To view other Z-Wave products and manuals from Z-Works follow that link.
Overview
Security
As a Z-Wave Plus certified product, Lock Dectector supports Z-Wave S2 security. The following security modes are directly supported:
Features
Z-Works describes Lock Dectector as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Using a paper clip or equivalent, push the button over 3 seconds.
(Please note that this product is reset if switch is pushed over 10 seconds)
Status LED turns off after adding.
Using a paper clip or equivalent, push the button over 3 seconds.
(Please note that this product is reset if switch is pushed over 10 seconds)
Status LED starts flashing after removal is finished.
Remove the battery and put it back after making sure the device is fully discharged. The device shall send the wake up notification.
Factory reset Lock Dectector
Using a paper clip or equivalent, push the button over 10 seconds.
Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Lock Dectector from Z-Works is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Lock Dectector and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.