The following is an overview of the user manual for the Z-Wave product Bulb 2 (rgbw2.eu)from Zipato. To view other Z-Wave products and manuals from Zipato follow that link.
Overview
Security
As a Z-Wave Plus certified product, Bulb 2 supports Z-Wave S2 security. The following security modes are directly supported:
Features
Zipato describes Bulb 2 as having the following features:
- Color
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Screw the RGBW bulb into a standard E27 socket.
2. Turn on the bulb with your wall switch to apply power to the bulb.
a) If you’re not using a wall switch, then use your alternate method to apply power to the bulb.
3. Activate the “included/excluded” mode on your Z-Wave controller or gateway.
a) This may also be done through your associated app, if your ecosystem has that capability.
4. Toggle the wall-switch, from OFF, then to ON.
a) Or use your alternate method to toggle power from OFF, then to ON.
5. The LED bulb will flash once if it has been successfully “included/ excluded” into your Z-Wave network.
Factory reset Bulb 2
Physically switch the bulb on and off six (6) times for intervals of 0.5-2 seconds. After the 6th time, the bulb will flash twice indicating that it’s successfully reset.A factory default is performed when the bulb is excluded from the Z-Wave network.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
1. Screw the RGBW bulb into a standard E27 socket.
2. Turn on the bulb with your wall switch to apply power to the bulb.
a) If you’re not using a wall switch, then use your alternate method to apply power to the bulb.
3. Activate the “included/excluded” mode on your Z-Wave controller or gateway.
a) This may also be done through your associated app, if your ecosystem has that capability.
4. Toggle the wall-switch, from OFF, then to ON.
a) Or use your alternate method to toggle power from OFF, then to ON.
5. The LED bulb will flash once if it has been successfully “included/ excluded” into your Z-Wave network.
Please note that this is a user manual Bulb 2 from Zipato is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Bulb 2 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.