The following is an overview of the user manual for the Z-Wave product Carbon Monoxide Sensor (hm-hs1ca-z.eu)from Zipato. To view other Z-Wave products and manuals from Zipato follow that link.
Overview
Security
As a Z-Wave Plus certified product, Carbon Monoxide Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Zipato describes Carbon Monoxide Sensor as having the following features:
- Color
- Supported Notification Types
- Battery Quantity
- Battery powered using CR17335 batteries
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Press button on sensor 3 times within 1.5s, Green LED will blink 3 times within 1 second.
If Inclusion Process is successful, Green led will turn off.
Press button on sensor 3 times within 1.5s, Green LED will blink 3 times within 1 second.
If Inclusion Process is successful, Green led will turn off.
Factory reset Carbon Monoxide Sensor
Remove battery.
Insert battery while holding button on sensor.
Please use this procedure only when the network primary
controller is missing or otherwise inoperable.
Wake up Notification is transmitted every 24 hours by default.
Wake up Notification is transmitted after Notification Report is Transmitted
Please note that this is a user manual Carbon Monoxide Sensor from Zipato is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Carbon Monoxide Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.