The following is an overview of the user manual for the Z-Wave product Flood Multisensor 3 in 1 - FLOHUTE, Z-Wave (ph-pat02.eu)from Zipato. To view other Z-Wave products and manuals from Zipato follow that link.
Overview
sensors in one device, connected to your Z-Wave network of choice.
This device offers elaborate safety and ambient sensing options.
Multifunctional nature of this product allows you to be informed
about water leakages and potential flood disasters, as well as to
measure temperature and humidity levels
Security
As a Z-Wave Plus certified product, Flood Multisensor 3 in 1 - FLOHUTE, Z-Wave supports Z-Wave S2 security. The following security modes are directly supported:
Features
Zipato describes Flood Multisensor 3 in 1 - FLOHUTE, Z-Wave as having the following features:
- Battery powered using CR123A batteries
- Color
- Sensors
- Supported Notification Types
- Battery Quantity
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Put Z-Wave Controller in Inclusion mode.
Press the tamper key three times within 1.5 seconds to enter the
Inclusion mode.
After successful join, the device will enter wake state for 20
seconds, in order to receive the setting command from Z-Wave
Controller.
Put Z-Wave Controller in Exclusion mode.
Press the tamper key three times within 1.5 seconds to enter the
Exclusion mode. Node ID has been excluded.
Factory reset Flood Multisensor 3 in 1 - FLOHUTE, Z-Wave
Notice: Use this procedure only in the event that the primary
controller is lost or otherwise inoperable.
Press the tamper key four times within 1.5 seconds and hold it
until LED lights up.
After 3 seconds the LED will turn OFF, and after that you should
release the tamper key within 2 seconds. If successful, the LED
will light up for one second. Otherwise, the LED will flash once.
IDs are excluded and all settings will reset to factory default.
When the device powers on, the device will be in wake state
for about 20 seconds. During this time, the controller can
communicate with the device. Normally the device is always
sleeping to save the battery energy.
Please note that this is a user manual Flood Multisensor 3 in 1 - FLOHUTE, Z-Wave from Zipato is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Flood Multisensor 3 in 1 - FLOHUTE, Z-Wave and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.