The following is an overview of the user manual for the Z-Wave product Keyfob 5 Remote, Z-Wave (ph-psr03.eu)from Zipato. To view other Z-Wave products and manuals from Zipato follow that link.
Overview
Security
As a Z-Wave Plus certified product, Keyfob 5 Remote, Z-Wave supports Z-Wave S2 security. The following security modes are directly supported:
Features
Zipato describes Keyfob 5 Remote, Z-Wave as having the following features:
- Battery powered using Li 602025 batteries
- Battery Quantity
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
After the device is added to the network, it will wake-up once per
day in default. When it wakes up it will broadcast the “Wake Up
Notification” message to the network, and wake-up 10 seconds to
receive the setting commands. To wake-up the device immediately,
please hold down the central key, then press the top-right key once
within. The device will wake-up for 10 seconds.
Put the Z-Wave Controller in exclusion mode. Hold down the central key, then press the top-right key 3 times within 1.5 seconds to enter exclusion mode. Node ID has been excluded.
Put the Z-Wave Controller in inclusion mode. Hold down the central key, then press the top-right key 3 times within 1.5 seconds to enter inclusion mode. After successful inclusion, the device will wake to receive the setting command from Z-Wave Controller in about 20 seconds.
Factory reset Keyfob 5 Remote, Z-Wave
Use this procedure only in the event that the primary controller is lost or otherwise inoperable.
Hold down the central key, then press the top-right key 4 times
within 1.5 seconds and during 4th press, hold the key until LED
lights up.
After 3 seconds the LED will turn OFF, and after next 2 seconds,
release the tamper key. If successful, the LED will light ON for
second. Otherwise, the LED will flash once. IDs are excluded and all settings will reset to factory default.
Please note that this is a user manual Keyfob 5 Remote, Z-Wave from Zipato is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Keyfob 5 Remote, Z-Wave and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.