The following is an overview of the user manual for the Z-Wave product Micro Module motor controller (ph-pan08.eu)from Zipato. To view other Z-Wave products and manuals from Zipato follow that link.
Overview
Micromodule Motor Controller is Z-Wave Plus enabled device which makes it compatible with any Z-Wave enabled network, regardless of the manufacturer. Slim design makes it easy to fit in majority of wall boxes. New smart-relay calibration technology reduces inrush current caused by the load and enables module to work perfectly with all kinds of roller shutters and blinds.
Micromodule is able to detect position of the Shutter by using the patterned power measuring method, so it can be remote controlled not only fully up or down, but also can be adjusted to ex. 30% or 50%. When manually operated by the push button, Micromodule Motor Controller can also memorize the position and send the new shutter position to its controller (ex. IP-Gateway).
Security
As a Z-Wave Plus certified product, Micro Module motor controller supports Z-Wave S2 security. The following security modes are directly supported:
Features
Zipato describes Micro Module motor controller as having the following features:
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Watts
- Loads Controlled
- Supported Meter Type
- Switch Type
- Window Covering Control Features
- Color
- Neutral Wire Required
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Micro Module motor controller
Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Pressing Include button three times within 2 seconds will enter inclusion mode.
Within 1 second, press Include button again for 5 seconds until LED is off.
IDs are excluded.
Put your Z-Wave controller into inclusion mode by following the instructions provided by the controller manufacturer.
Pressing Include button three times within 2 seconds will enter inclusion mode.
Put the Z-Wave Controller in exclusion mode.
Pressing Include button three times within 2 seconds will enter exclusion mode.
Node ID has been excluded.
Please note that this is a user manual Micro Module motor controller from Zipato is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Micro Module motor controller and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.