Micro Module Switch Double w.meter (ph-pan04.eu) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Micro Module Switch Double w.meter (ph-pan04.eu)from Zipato. To view other Z-Wave products and manuals from Zipato follow that link.

Overview
Security
Features
Installation instructions

Overview

Name

Micro Module Switch Double w.meter

SKU Code

ph-pan04.eu

Description

This product can be operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network. Micromodule Switch Double is a transceiver which is a Z-Wave Plus enabled device and is fully compatible with any Z-Wave enabled network. Mini size design allow the module to be easily hidden into the wall box which is good for the house decoration. There are many kinds of application for using the module to switch AC power ON and OFF, one of which is the light control. The new smart relay calibration technology can reduce the inrush current caused by the load and let the module work perfectly with many kinds of light like incandescent, fluorescent and LED light. This Micromodule is able to detect Instant power wattage and overload wattage (current 7.5A) of connected light or appliances. When detecting overload state, the switch will be disabled and its ON/OFF button will be locked during which LED will flash repeatedly. Unplugging and reconnecting the Module will reset its overload condition to normal status.

Version #

HW: 1 FW: 1.08 was the version certified

Certification #

ZC10-17065647

Certified

2017-06-07T22:40:15.31687

Z-Wave Version

6.51.02

Security

As a Z-Wave Plus certified product, Micro Module Switch Double w.meter supports Z-Wave S2 security. The following security modes are directly supported:

Features

Zipato describes Micro Module Switch Double w.meter as having the following features:

Firmware updatable via a compatible Z-Wave gateway
Switch Load Capacity Current
Supported Meter Type
Color
Electric Load Type
Switch Type
FLiRS capable
Supports Network Wide Inclusion
Supports Z-Wave Explorer Frames
Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

Factory reset Micro Module Switch Double w.meter

Use this procedure only in the event that the network primary controller is lost or otherwise inoperable.
Pressing INCLUDE_BUTTON three times within 2 seconds will enter inclusion mode.
Within 1 second, press On/Off button again for 5 seconds until LED is off.
IDs are excluded.

Have Z-Wave Controller entered exclusion mode by following the instructions provided by the controller manufacturer.
Pressing INCLUDE_BUTTON three times within 2 seconds will enter exclusion mode.
Node ID has been excluded.

Have Z-Wave Controller entered inclusion mode by following the instructions provided by the controller manufacturer.
Pressing INCLUDE_BUTTON threetimes within 2 seconds will enter inclusion mode.

Please note that this is a user manual Micro Module Switch Double w.meter from Zipato is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Micro Module Switch Double w.meter and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.

Categories