Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Micromodule Energy Meter, Z-Wave (ph-pab01) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Micromodule Energy Meter, Z-Wave (ph-pab01)from Zipato. To view other Z-Wave products and manuals from Zipato follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Micromodule Energy Meter, Z-Wave
SKU Code
ph-pab01
Description
This product can be operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network. Zipato Energy Meter monitors total electricity consumption of connected appliances and reports it to Zipato or any other Z-Wave enabled controller in real time. Small and compact size allows easy installation in majority of electricity distribution boxes. It supports two loads upto 6000W each (@ 120V).
Version #
HW: 1 FW: 1.02 was the version certified
Certification #
ZC10-17065646
Certified
2017-06-08T04:18:18.263988
Z-Wave Version
6.51.06

Security

As a Z-Wave Plus certified product, Micromodule Energy Meter, Z-Wave supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Zipato describes Micromodule Energy Meter, Z-Wave as having the following features:

    • Color
    • Switch Load Capacity Current
    • Electric Load Type
    • Firmware updatable via a compatible Z-Wave gateway
    • Supported Meter Type
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Factory reset Micromodule Energy Meter, Z-Wave

    Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
    Pressing On/Off (Include) button three times within 2 seconds will enter inclusion mode.
    Within 1 second, press and hold On/Off (Include) button again for 5 seconds until LED is off.
    IDs are excluded.

    Put your Z-Wave controller into inclusion mode by following the instructions provided by the controller manufacturer.
    Pressing On/Off (Include) button three times within 2 seconds will enter inclusion mode.

    Put your Z-Wave controller into exclusion mode by following the instructions provided by the controller manufacturer.
    Pressing On/Off (Include) button three times within 2 seconds will enter exclusion mode.
    Node ID has been excluded.

    Please note that this is a user manual Micromodule Energy Meter, Z-Wave from Zipato is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Micromodule Energy Meter, Z-Wave and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.