The following is an overview of the user manual for the Z-Wave product Multisensor Duo (vs-zp3102+.us)from Zipato. To view other Z-Wave products and manuals from Zipato follow that link.
As a Z-Wave Plus certified product, Multisensor Duo supports Z-Wave S2 security. The following security modes are directly supported:
Zipato describes Multisensor Duo as having the following features:
- Battery Quantity
- Battery powered using CR123 batteries
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Z-Wave Controller into “exclusion” mode, and follow the instructions
to remove the Multisensor Duo from you controller network. Press
the program switch of Multisensor Duo once to be excluded. The
LED on the Multisensor Duo should start to flash.
Put your Z-Wave
Controller into “inclusion” mode, and follow the instructions to add
Multisensor Duo to your controller. To get in the “inclusion” mode,
the distance between sensor and controller should be up to 1 meter.
Press the program switch of Multisensor Duo once. The LED on the
sensor should stop flashing, if not, please try again.
It will be triggered after opening the front cover.
Red LED will last 10 seconds and Multisensor Duo will send “Wake
Up Notification” after 10 seconds.
Factory reset Multisensor Duo
Remove cover to trigged tamper
switch, LED ON & send out Alarm Report. Press Program Switch
10 times within 10 seconds. Multisensor Duo will send the “Device
Reset Locally Notification” command and reset to the factory
(Remark: This is to be done only in case of primary
controller being inoperable or otherwise unavailable.)
Please note that this is a user manual Multisensor Duo from Zipato is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Multisensor Duo and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.