Multisensor QUAD - MODOLITE, Z-wave ( manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Multisensor QUAD - MODOLITE, Z-wave ( Zipato. To view other Z-Wave products and manuals from Zipato follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


Multisensor QUAD - MODOLITE, Z-wave
SKU Code
Zipato Multisensor Quad offers elaborate security and ambient sensing options. Multifunctional nature of this product allows you to detect motion, monitor opened/closed status of any opening object, measure room’s ambient temperature and light intensity.
Version #
HW: 1 FW: 1.29:01.22 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, Multisensor QUAD - MODOLITE, Z-wave supports Z-Wave S2 security. The following security modes are directly supported:


    Zipato describes Multisensor QUAD - MODOLITE, Z-wave as having the following features:

    • Battery powered using CR123A batteries
    • Color
    • Sensors
    • Supported Notification Types
    • Battery Quantity
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    If the user want to wake-up the device immediately, please remove
    the front cover, and press the tamper key once. The device will
    wake-up 10 seconds.

    Put the Z-Wave Controller in inclusion mode. Pressing tamper key three times within 1.5 seconds will enter inclusion mode.
    After successful inclusion, the device will wake to receive the
    setting command from Z-Wave Controller in about 20 seconds.

    Put the Z-Wave Controller in exclusion mode. Pressing tamper key three times within 1.5 seconds will enter exclusion mode. Node ID has been excluded.

    Factory reset Multisensor QUAD - MODOLITE, Z-wave

    Use this procedure only in the event that the primary controller
    is lost or otherwise inoperable.
    Pressing tamper key four times within 1.5 seconds and during
    4th press, hold the tamper key until LED lights up. After 3 seconds the LED will turn OFF, and after next 2 seconds, release the tamper key. If successful, the LED will light ON for one second. Otherwise, the LED will flash once.IDs are excluded and all settings will reset to factory default.

    Please note that this is a user manual Multisensor QUAD - MODOLITE, Z-wave from Zipato is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. only warrants and is only able to support products purchased directly from us. If you have Multisensor QUAD - MODOLITE, Z-wave and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.