The following is an overview of the user manual for the Z-Wave product Multisensor TRIO - DOLITE, Z-wave (ph-psm01.eu)from Zipato. To view other Z-Wave products and manuals from Zipato follow that link.
Overview
Security
As a Z-Wave Plus certified product, Multisensor TRIO - DOLITE, Z-wave supports Z-Wave S2 security. The following security modes are directly supported:
Features
Zipato describes Multisensor TRIO - DOLITE, Z-wave as having the following features:
- Battery powered using CR123A batteries
- Battery Quantity
- Color
- Sensors
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Put the Z-Wave Controller in inclusion mode. Pressing tamper key three times within 1.5 seconds will enter inclusion mode.
After successful inclusion, the device will wake to receive the
setting command from Z-Wave Controller in about 20 seconds.
Put the Z-Wave Controller in exclusion mode. Pressing tamper key three times within 1.5 seconds will enter exclusion mode. Node ID has been excluded.
If the user want to wake-up the device immediately, please remove
the front cover, and press the tamper key once. The device will
wake-up 10 seconds.
Factory reset Multisensor TRIO - DOLITE, Z-wave
Use this procedure only in the event that the primary controller is lost or otherwise inoperable.
Pressing tamper key four times within 1.5 seconds and during
4th press, hold the tamper key until LED lights up. After 3 seconds the LED will turn OFF, and after next 2 seconds, release the tamper key. If successful, the LED will light ON for one second. Otherwise, the LED will flash once.IDs are excluded and all settings will reset to factory default.
Please note that this is a user manual Multisensor TRIO - DOLITE, Z-wave from Zipato is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Multisensor TRIO - DOLITE, Z-wave and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.