The following is an overview of the user manual for the Z-Wave product PIR Sensor (ne-nas-pd01zt.eu)from Zipato. To view other Z-Wave products and manuals from Zipato follow that link.
Overview
Security
As a Z-Wave Plus certified product, PIR Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Zipato describes PIR Sensor as having the following features:
- Battery powered using CR17345 batteries
- Color
- Sensors
- Supported Notification Types
- Battery Quantity
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
You can press the button once to wake up the device and send wakeup notification to controller. If press successfully, the LED will blink one time
Factory reset PIR Sensor
Reset procedure will delete all information on the Z‐Wave network and Z‐Wave controller or Z‐Wave Gateway, and restore the sensor to factory default settings.
1.Remove the device cover.
2.Make sure the sensor is powered.
3.Press and hold the button for 10 seconds, Led will blink once.
4.Release the button.
Note: to use the reset procedure only when the primary controller is missing or inoperable.
1.Remove the device cover.
2.Make sure the sensor is powered.
3.Set Z‐Wave controller or Z‐Wave gateway into exclusion mode (Refer to the controller or gateway operating manual)
4.Press the button three times within 1.5 second, the device will enter exclusion mode.
1.Remove the sensor cover.
2.Make sure the sensor is powered.
3.Set Z‐Wave controller or Z‐Wave gateway into inclusion mode (Refer to the controller or gateway operating manual)
4.Press the button three times within 1.5 second, the device will enter inclusion mode. And the LED will flash on and off alternately five times.
Please note that this is a user manual PIR Sensor from Zipato is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have PIR Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.