Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Smart energy plug-in switch (ph-pan15.us) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Smart energy plug-in switch (ph-pan15.us)from Zipato. To view other Z-Wave products and manuals from Zipato follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Smart energy plug-in switch
SKU Code
ph-pan15.us
Description
The product documentation states a Security Enabled Z-Wave Controller must be used in order to fully utilize the product. Smart Energy Plug In Switch is a security enabled wireless switch, based on Z-Wave Plus technology. Z-Wave Plus enabled devices displaying the Z-Wave Plus logo can also be used with it regardless of the manufacturer, and can also be used in other manufacturer’s Z-Wave enabled networks. Remote On/Off control of the connected load is possible with other manufacturer’s wireless Controller. Each switch is designed to act as a repeater. Repeaters will re-transmit the RF signal to ensure that the signal is received by its intended destination by routing the signal around obstacles and radio dead spots. Because the Switch supports Security Command Class, it can learn with Secured controller. Its functionality and supported command classes is identical when included as a secure and non-secure device.This Smart Energy Plug In Switch is able to detect instance wattage (1560W/UL/TW/JP) and overload current (14.5A) of connected lights or appliances. When detecting overload state, the Switch will be disabled and its On/Off button will be lockout of which LED will flash quickly. However, unplug and reconnect the switch will reset its overload condition to normal status.
Version #
HW: 1 FW: 1.03 was the version certified
Certification #
ZC10-17055606
Certified
2017-05-22T22:57:21.015741
Z-Wave Version
6.51.06

Security

As a Z-Wave Plus certified product, Smart energy plug-in switch supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Zipato describes Smart energy plug-in switch as having the following features:

    • Color
    • Electric Load Type
    • Firmware updatable via a compatible Z-Wave gateway
    • Switch Load Capacity Watts
    • Supported Meter Type
    • Switch Type
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Factory reset Smart energy plug-in switch

    Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
    Pressing On/Off button three times within 2 seconds will enter inclusion mode.
    Within 1 second, press On/Off button again for 5 seconds.
    IDs are excluded.

    Put your Z-Wave controller into inclusion mode by following the instructions provided by the controller manufacturer.
    Pressing On/Off button three times within 2 seconds will enter inclusion mode.

    Put your Z-Wave controller into exclusion mode by following the instructions provided by the controller manufacturer.
    Pressing On/Off button three times within 2 seconds will enter exclusion mode.
    Node ID has been excluded.

    Please note that this is a user manual Smart energy plug-in switch from Zipato is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart energy plug-in switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.