The following is an overview of the user manual for the Z-Wave product Smart energy plug-in switch (ph-pan16.eu)from Zipato. To view other Z-Wave products and manuals from Zipato follow that link.
Overview
Repeaters will re-transmit the RF signal to ensure that the signal is received by its intended destination by routing the signal around obstacles and radio dead spots. Because the Switch supports Security Command Class, it can learn with Secured controller. Its functionality and supported command classes is identical when included as a secure and non-secure device. This Smart Energy Plug In Switch is able to detect instance wattage (3000W/230Vac) (13Ampere) and overload current (14.5A with resistive load) of connected lights or appliances. When detecting overload state, the Switch will be disabled and its On/Off button will be lockout of which LED will flash quickly. However, unplug and reconnect the switch will reset its overload condition to normal status.
Security
As a Z-Wave Plus certified product, Smart energy plug-in switch supports Z-Wave S2 security. The following security modes are directly supported:
Features
Zipato describes Smart energy plug-in switch as having the following features:
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Current
- Supported Meter Type
- Color
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Smart energy plug-in switch
Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Pressing On/Off button three times within 2 seconds will enter inclusion mode.
Within 1 second, press On/Off button again for 5 seconds.
IDs are excluded.
Put your Z-Wave controller into inclusion mode by following the instructions provided by the controller manufacturer.
Pressing On/Off button three times within 2 seconds will enter inclusion mode.
Put your Z-Wave controller into exclusion mode by following the instructions provided by the controller manufacturer.
Pressing On/Off button three times within 2 seconds will enter exclusion mode.
Node ID has been excluded.
Please note that this is a user manual Smart energy plug-in switch from Zipato is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart energy plug-in switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.