The following is an overview of the user manual for the Z-Wave product Smoke Sensor, Z-Wave (ph-psg01.eu)from Zipato. To view other Z-Wave products and manuals from Zipato follow that link.
Overview
Security
As a Z-Wave Plus certified product, Smoke Sensor, Z-Wave supports Z-Wave S2 security. The following security modes are directly supported:
Features
Zipato describes Smoke Sensor, Z-Wave as having the following features:
- Battery Quantity
- Color
- Supported Notification Types
- Battery powered using CR123A batteries
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Have Z-Wave Controller entered inclusion mode.
2. Press test button three times within 1.5 seconds to enter the inclusion mode.
3. After the adding was successful, the device will wake to receive the setting from Z-Wave Controller about 20 seconds.
1. Have Z-Wave Controller entered inclusion mode.
2. Pressing test button three times within 1.5 seconds to enter the exclusion mode. Node ID has been removed.
Factory reset Smoke Sensor, Z-Wave
Notice: Use this procedure only in the event that the primary controller is lost or otherwise inoperable.
1. Have Z-Wave Controller entered inclusion mode.
2. After the red LED flash 9 times, release the test button within 2 seconds.
3. IDs are removed and all settings will reset to factory default.
After device is added to the network, it will wake-up once per day by default.When it wakes-up it will broadcast the “Wake Up Notification” message to the network, and wake-up 10 seconds
to receive the setting commands. The wake-up interval minimum
setting is 30 minutes, and maximum setting is 120 hours. Interval
step is 30 minutes. If you want to wake-up device immediately, please press the button once. The device will wake-up for 10 seconds.
Please note that this is a user manual Smoke Sensor, Z-Wave from Zipato is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smoke Sensor, Z-Wave and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.