The following is an overview of the user manual for the Z-Wave product Zipatile (zt.zweuzbee.b)from Zipato. To view other Z-Wave products and manuals from Zipato follow that link.
Overview
Security
As a Z-Wave Plus certified product, Zipatile supports Z-Wave S2 security. The following security modes are directly supported:
Features
Zipato describes Zipatile as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Sensors
- Z-Wave Scene Type
- Communications Protocol
- Loads Controlled
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
* Navigate to Z-Wave network management tools
* Click the “Remove node” button and follow onscreen instructions
It is recommended to add new devices with the device manager by pressing the “Add New Device” button. Select the Z-Wave logo and follow on-screen instructions.
* Navigate to Z-Wave network management tools
* Click the “START LEARN MODE” button and follow onscreen instructions.
Factory reset Zipatile
* Navigate to Z-Wave network management tools
* Click the “Z-WAVE RESET” button and follow onscreen instructions.
Please note that this is a user manual Zipatile from Zipato is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Zipatile and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.