Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Z-Wave In-Wall On/Off Switch (WS-100) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Z-Wave In-Wall On/Off Switch (WS-100)from ZLINK. To view other Z-Wave products and manuals from ZLINK follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Z-Wave In-Wall On/Off Switch
SKU Code
WS-100
Description
ZLINK’s WS-100 is a Z-Wave Plus certified device with S2 security and Smart Start features. You can now add this device securely and with ease using QR code on the product with compatible gateways supporting S2 and Smart Start. Sleek WS-100 communicates with other Z-Wave certified devices and updates your home into a smart home. ZLINK WS-100 replaces a standard in-wall light switch turning it into a Z-Wave controlled network device with manual and remote ON/OFF control. ZLINK WS-100 supports, “Instant Feedback” of manual status to compatible gateways as well as Central Scene to allow setting multiple scene control throughout the home, with gateways supporting Central Scene. Each Z-Wave device serves as a node to repeat the signal in the network, thus, extending the overall Z-Wave mesh wireless network range.
Additional Features:
• Power 120 VAC, 60Hz, up to 1800 watts
• Region US: 908.4, 916 MHz
• Works with incandescent, CFL & LED lights
• Remotely or manually turns ON or OFF lights
• Fits standard wall plates (wall plate not included)
• Works with any certified gateway supporting Z-Wave
Version #
HW: 255 FW: 50.03 was the version certified
Certification #
ZC10-18025995
Certified
2018-02-07T22:34:12.148082
Z-Wave Version
6.81.00

Security

As a Z-Wave Plus certified product, Z-Wave In-Wall On/Off Switch supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Authenticated
  • S2 Unauthenticated

Features

ZLINK describes Z-Wave In-Wall On/Off Switch as having the following features:

  • Color
  • Outdoor Use
  • Z-Wave Scene Type
  • Firmware updatable via a compatible Z-Wave gateway
  • Neutral Wire Required
  • Switch Load Capacity Volt-Ampere
  • Switch Type
  • Switch Load Capacity Watts
  • Switch Load Capacity Current
  • Electric Load Type
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

Place your Z-Wave controller in ""Inclusion"" mode. Then tap either the top or bottom paddle once to initiation Inclusion.

Place your Z-Wave controller in ""Exclusion"" mode. Then tap either the top or bottom paddle once to initiation Exclusion.

Factory reset Z-Wave In-Wall On/Off Switch

1. Turn the connected light ON with the rocker
2. Quickly tap the topside of the rocker 3 times
3. Then quickly tap the bottom side of the rocker 3 times
If you see the lights turn OFF then ON it means that the module has been reset successfully.

Please use this procedure only when the network primary controller is missing or otherwise inoperable.

Please note that this is a user manual Z-Wave In-Wall On/Off Switch from ZLINK is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave In-Wall On/Off Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.