Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Z-Wave Plug-In Dimmer (PD-100) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Z-Wave Plug-In Dimmer (PD-100)from ZLINK. To view other Z-Wave products and manuals from ZLINK follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Z-Wave Plug-In Dimmer
SKU Code
PD-100
Description
ZLINK PD-100 is a Z-Wave Plus certified device with S2 security and SmartStart features. You can now add this device securely and with ease using QR code on the product with compatible gateways supporting S2 and Smart Start. PD-100 communicates with other Z-Wave certified devices and updates your home into a smart home. PD-100 can be used to turn any plug in lamps into a smart lamp with dimmable light bulbs, turning it On, Off, or control dimming wirelessly. Each Z-Wave device also serves as a node to repeat the signal in the network, thus, extending the overall Z-Wave mesh wireless network range.
Additional Features:
• Power 120 VAC, 60Hz, up to 300 watts
• Region US: 908.4, 916 MHz
• Works w/ most incandescent, dimmable CFL & LED lights
• Plugs into Standard AC outlet
• Remotely controls On, Off, or Dim levels
• Control lights via schedule
• LED backlit manual On/Off button
• Second wall AC outlet remains free
• Works with any certified gateway supporting Z-Wave
Version #
HW: 255 FW: 50.03 was the version certified
Certification #
ZC10-18025997
Certified
2018-02-07T22:34:41.772263
Z-Wave Version
6.81.00

Security

As a Z-Wave Plus certified product, Z-Wave Plug-In Dimmer supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Authenticated
  • S2 Unauthenticated

Features

ZLINK describes Z-Wave Plug-In Dimmer as having the following features:

  • Color
  • Outdoor Use
  • Firmware updatable via a compatible Z-Wave gateway
  • Switch Load Capacity Volt-Ampere
  • Switch Type
  • Electric Load Type
  • Switch Load Capacity Current
  • Switch Load Capacity Watts
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

Place your Z-Wave controller in ""Inclusion"" mode. Then tap the button once to initiation Inclusion.

Place your Z-Wave controller in ""Exclusion"" mode. Then tap the button to initiation Exclusion.

Factory reset Z-Wave Plug-In Dimmer

1. Unplug the PD-100 from the AC outlet and also unplug the power plugs of the lighting from the module (if plugged in)
2. Press and hold the button on the PD-100
3. Plug the PD-100 back into the AC outlet with the button pressed
After 3 seconds, release the button. If you see the button blink, that means that PD-100 has been reset successfully.

Please use this procedure only when the network primary controller is missing or otherwise inoperable.

Please note that this is a user manual Z-Wave Plug-In Dimmer from ZLINK is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Plug-In Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.