The following is an overview of the user manual for the Z-Wave product G-pon Onu (F2886S)from ZTE Corporation. To view other Z-Wave products and manuals from ZTE follow that link.
Overview
IoT devices such as sensors are connected and can be controlled with this device.
This device supports various interfaces for the functionalities of Wireless LAN, Z-Wave.
The device can collect sensing data from various Z-Wave sensor devices, and uploading of the data to a cloud server by PON interface is available.
The ONU Integrated Service Router has the following general features:
- 4 LAN Ports
- Wireless LAN interface
- Z-Wave communication
Security
As a Z-Wave Plus certified product, G-pon Onu supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
- S2 Authenticated
- S2 Unauthenticated
Features
ZTE describes G-pon Onu as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To add a device to the Z-Wave network, press the “Inclusion” button in the Android Controller Application.
To remove a device from the Z-Wave network, press the “Exclusion” button in the Android Controller Application.
Factory reset G-pon Onu
Press “RESET” in the Factory Default Reset dialog. This will reset the Z- Wave chip, and the gateway will show “DEVICE RESET LOCALLY NOTIFICATION” after the restart.
SmartStart location
SmartStart QR code's location as follows: Press “DSK” to display the DSK.
SmartStart installation
Press “Add” to display the camera screen.
As the camera starts, hold it over the QR code.
Register the DSK when you correctly hold the camera over a QR code on the product label.
To add a device to the Z-Wave network, press the “Inclusion” button in the Android Controller Application.
To remove a device from the Z-Wave network, press the “Exclusion” button in the Android Controller Application.
When tapping the Setting button, a Settings dialog will be displayed.
SmartStart > Show Provisioning List.
Display the registered provisioning list (DSK and inclusion status). Press an item in the list to delete it.
To add an IoT gateway into another Z-Wave network as a secondary controller or inclusion controller, press “Learn Mode
Classic” or “Learn Mode NWI” in the Settings dialog.
In the event that the gateway is already the controller of the Z-Wave network, put the gateway into Inclusion Mode, and
put another controller into the Learn Mode. The Replication will begin and network information will be sent to another
controller. In the event that the gateway is integrated into an existing Z-Wave network, put the gateway into Learn Mode,
and put the existing controller into Inclusion Mode. The Replication will begin and network information will be received
from the existing controller.
Please note that this is a user manual G-pon Onu from ZTE Corporation is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have G-pon Onu and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.