AërQ - Temperature & Humidity Sensor (ZWA009-A) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product AërQ - Temperature & Humidity Sensor (ZWA009-A)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
AërQ - Temperature & Humidity Sensor
SKU Code
ZWA009-A
Description
The AërQ is an intelligent sensor to monitor your environment at home. It measures temperature and humidity. Via an intelligent analysis, the sensor protects your health by detecting the danger of mould formations.
Version #
HW: 1 FW: 1.00 was the version certified
Certification #
ZC12-20090122
Certified
2020-09-21T16:02:06.592469
Z-Wave Version
7.12.2

Security

As a Z-Wave Plus certified product, AërQ - Temperature & Humidity Sensor supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Authenticated
  • S2 Unauthenticated

Features

Aeotec describes AërQ - Temperature & Humidity Sensor as having the following features:

  • Battery powered using batteries
  • Color
  • Battery Quantity
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

SmartStart location

SmartStart QR code's location as follows: To run this device please insert fresh 1 * CR2477 batteries. Please make sure the internal battery is fully charged. Triple clicking the central button includes (adds) and excludes (removes) the device. A click on the central button will wake up the device. The device supports the Security S2 framework with unauthenticated and authenticated network keys. The DSK for the S2 inclusion can be found inside the sensors packaging. Please follow the instructions on the central controller when including.
The device also supports Smart Start. Please scan the QR code on the outlet cover of the device and your controller will add the device automatically when powered up.

Inclusion
1. Insert the battery.
2. Press the button quickly three times in a row.

Exclusion
1. Press the button quickly three times in a row.

A click on the central button will wake up the device.

Factory reset AërQ - Temperature & Humidity Sensor

Reset to factory default
This device also allows to be reset without any involvement of a Z-Wave controller. This procedure should only be used when the primary controller is inoperable.
Keep the button pressed for 10 seconds. After 5 seconds the red LED will start blinking.

Please note that this is a user manual AërQ - Temperature & Humidity Sensor from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have AërQ - Temperature & Humidity Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.