The following is an overview of the user manual for the Z-Wave product Door/Window Sensor 7 (ZWA008-A)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.
Overview
Security
As a Z-Wave Plus certified product, Door/Window Sensor 7 supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Aeotec describes Door/Window Sensor 7 as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Sensors
- Supported Notification Types
- Battery Quantity
- Battery powered using 1/AA batteries
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
A single click on the tamper button will wakeup the device.
It supports connecting external sensor. E.g. Dry Contact Sensor, Water Sensor probes.
Tripple clicking the tamper button includes (adds) the device.
Tripple clicking the tamper button excludes (removes) the device.
Factory reset Door/Window Sensor 7
This device also allows to be reset without any involvement of a Z-Wave controller. This procedure should only be used when the primary controller is inoperable.
Once Cover is removed and tamper switch is tripped, push the tamper for 5 seconds until red LED blinks. Then release tamper and push it again for 5 seconds until LED blinks.
Please note that this is a user manual Door/Window Sensor 7 from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Door/Window Sensor 7 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.