The following is an overview of the user manual for the Z-Wave product Doorbell Gen5 (ZW056-B)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.
Overview
There is a small Wireless Button, which can trigger the doorbell on the other side of the wall to play the selected doorbell music when pressed.
It also act as a repeater that forward Z-Wave command messages to destination nodes if the originating controller is out of range from the destination node.
By taking advantage of the Z-Wave mesh network, commands can be routed to their destination via intermediary “listening” Z-Wave products. Products that are Z-Wave certified can be used and communicate with other Z-Wave certified devices.
Also a tool that can be programmed, scheduled, controlled and communicated with from anywhere in the world.
Security
As a Z-Wave Plus certified product, Doorbell Gen5 supports Z-Wave S2 security. The following security modes are directly supported:
Features
Aeotec describes Doorbell Gen5 as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Turn the primary controller of Z-Wave network into inclusion mode, short press the product’s Action button that you can find on the product's housing.
Turn the primary controller of Z-Wave network into exclusion mode, short press the product’s Action button that you can find on the product's housing.
Factory reset Doorbell Gen5
Press and hold the Action button that you can find on the product's housing for 20 seconds and then release. This procedure should only be used when the primary controller is missing or inoperable.
1. Support ""Over the Air Firmware Updating"" and “Z-Wave Security”.
2. Support doorbell music updating.
Please note that this is a user manual Doorbell Gen5 from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Doorbell Gen5 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.