The following is an overview of the user manual for the Z-Wave product Dual Nano Switch (ZW140-D)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.
Overview
In the event of power failure, non-volatile memory retains all programmed information relating to the unit’s operating status.
It can connect to 2 external manual switches to control the load ON/OFF independently. Its surface has a pin socket, which can be used for connecting to the touch panel, so you can also use the touch panel to control the Dual Nano Switch.
The Dual In-Wall Switch is also a security Z-Wave device and supports Over The Air (OTA) feature for the products firmware upgrade.
Security
As a Z-Wave Plus certified product, Dual Nano Switch supports Z-Wave S2 security. The following security modes are directly supported:
Features
Aeotec describes Dual Nano Switch as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Switch Type
- Z-Wave Scene Type
- Electric Load Type
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Turn the primary controller of Z-Wave network into inclusion mode, short press the product’s Action button that you can find on the product's housing.
Turn the primary controller of Z-Wave network into exclusion mode, short press the product’s Action button that you can find on the product's housing.
Support ""Over the Air Firmware Updating"" and “Z-Wave Security”.
Factory reset Dual Nano Switch
Press and hold the Action button that you can find on the product's housing for 20 seconds and then release. This procedure should only be used when the primary controller is inoperable.
Please note that this is a user manual Dual Nano Switch from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Dual Nano Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.