The following is an overview of the user manual for the Z-Wave product Garage Door Controller Gen5 (ZW062-C)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.
Overview
The Garage Door Controller allows you to configure different alarm sounds to indicate the door’s action. Each action alarm sound can be customized. To change or update new alarm sounds for the Garage Door Controller, connect the Garage Door Controller to your PC host with a USB cable and download your sound files to the flash memory (128 MB) of the Garage Door Controller.
It can be included and operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers and/or other applications. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.
It is also a security Z-Wave device and supports the Over The Air (OTA) feature for the product’s firmware upgrade.
Security
As a Z-Wave Plus certified product, Garage Door Controller Gen5 supports Z-Wave S2 security. The following security modes are directly supported:
Features
Aeotec describes Garage Door Controller Gen5 as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Garage Door Controller Gen5
Press and hold the Z-Wave button that you can find on the product's housing for 20 seconds and then release. This procedure should only be used when the primary controller is missing or inoperable.
1. Support ""Over the Air Firmware Updating"" and “Z-Wave Security”.
2. Support alarm sound updating.
Turn the primary controller of Z-Wave network into inclusion mode, short press the product’s Z-Wave button that you can find on the product's housing.
Turn the primary controller of Z-Wave network into exclusion mode, short press the product’s Z-Wave button that you can find on the product's housing.
Please note that this is a user manual Garage Door Controller Gen5 from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Garage Door Controller Gen5 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.