The following is an overview of the user manual for the Z-Wave product Heavy Duty Smart Switch Gen5 (ZW078-A_Aeon_1406)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.
Overview
By taking advantage of the Z-Wave mesh network, commands can be routed to their destination via intermediary “listening” Z-Wave products. Products that are Z-Wave certified can be used and communicate with other Z-Wave certified devices.
Security
As a Z-Wave Plus certified product, Heavy Duty Smart Switch Gen5 supports Z-Wave S2 security. The following security modes are directly supported:
Features
Aeotec describes Heavy Duty Smart Switch Gen5 as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Turn the primary controller of Z-Wave network into inclusion mode, short press the product’s Z-Wave button.
Turn the primary controller of Z-Wave network into exclusion mode, short press the product’s Z-Wave button.
N/A
Factory reset Heavy Duty Smart Switch Gen5
Press and hold the Z-Wave button for 20 seconds and then release.
N/A
Measuring the temperature inside the product.
Please note that this is a user manual Heavy Duty Smart Switch Gen5 from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Heavy Duty Smart Switch Gen5 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.