Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Heavy Duty Smart Switch Gen5 (ZW078-C) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Heavy Duty Smart Switch Gen5 (ZW078-C)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Heavy Duty Smart Switch Gen5
SKU Code
ZW078-C
Description
Aeon Labs Heavy Duty Smart Switch is a Z-Wave device that can report the wattage energy usage and KWH usage to a Z-Wave Controller (especially a gateway), it can be controlled by other Z-Wave devices to turn on/off loads, it can bear up to 40A current of resister loads. It also acts as a repeater that forward Z-Wave command messages to destination nodes if the originating controller is out of range from the destination node.
By taking advantage of the Z-Wave mesh network, commands can be routed to their destination via intermediary “listening” Z-Wave products. Products that are Z-Wave certified can be used and communicate with other Z-Wave certified devices.

Version #
HW: 78 FW: 3.26 was the version certified
Certification #
ZC10-14090016
Certified
2014-09-12T18:12:39.84641
Z-Wave Version
6.51.00

Security

As a Z-Wave Plus certified product, Heavy Duty Smart Switch Gen5 supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Aeotec describes Heavy Duty Smart Switch Gen5 as having the following features:

    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Turn the primary controller of Z-Wave network into inclusion mode, short press the product’s Action button that you can find on the product's housing.

    Turn the primary controller of Z-Wave network into exclusion mode, short press the product’s Action button that you can find on the product's housing.

    N/A

    Factory reset Heavy Duty Smart Switch Gen5

    Press and hold the Action button that you can find on the product's housing for 20 seconds and then release. This procedure should only be used when the primary controller is inoperable.

    N/A

    Support ""Over the Air Firmware Updating"" and “Z-Wave Security”.

    Please note that this is a user manual Heavy Duty Smart Switch Gen5 from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Heavy Duty Smart Switch Gen5 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.