The following is an overview of the user manual for the Z-Wave product Home Energy Meter Gen5 (ZW095-A)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.
Overview
It can report the wattage energy usage and KWH usage to a Z-Wave Controller (especially a gateway). In near real-time you’ll have a full understanding of how much electricity you use and when you use it.
Products that are Z-Wave certified can be used and communicate with other Z-Wave certified devices. Also a tool that can be programmed, scheduled, controlled and communicated with from anywhere in the world.
Security
As a Z-Wave Plus certified product, Home Energy Meter Gen5 supports Z-Wave S2 security. The following security modes are directly supported:
Features
Aeotec describes Home Energy Meter Gen5 as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Turn the primary controller of Z-Wave network into inclusion mode, short press the product’s Action button that you can find on the product's housing.
Turn the primary controller of Z-Wave network into exclusion mode, short press the product’s Action button that you can find on the product's housing.
Support ""Over the Air Firmware Updating"" and “Z-Wave Security”.
N/A
Factory reset Home Energy Meter Gen5
Press and hold the Action button that you can find on the product's housing for 10 seconds and then release. This procedure should only be used when the primary controller is inoperable.
N/A
Please note that this is a user manual Home Energy Meter Gen5 from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Home Energy Meter Gen5 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.