The following is an overview of the user manual for the Z-Wave product Home Energy Meter Gen5 (ZW095-C)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.
Overview
It can be included and operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers and/or other applications. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.
It is a security enabled Z-Wave plus device supports the Security Command Class and has the AES-128 bit security encryption built right in. While a Security enabled Controller is needed in order to fully use the security feature.
It also supports the Over The Air (OTA) feature for the product’s firmware upgrade.
Security
As a Z-Wave Plus certified product, Home Energy Meter Gen5 supports Z-Wave S2 security. The following security modes are directly supported:
Features
Aeotec describes Home Energy Meter Gen5 as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Power on the HEM, the LED will blink slowly.
2. Let the primary controller into inclusion mode (If you don’t know how to do this, refer to its manual).
3. Click or double-click the Action Button.
4. If the inclusion is success, the LED will be solid. If the LED still blinks slowly,please repeat the process from step
2
1. Power on the HEM, the LED will be solid.
2. Let the primary controller of existing Z-Wave network into remove mode (If you don’t know how to do this, refer to its manual).
3. Press the Action Button.
4. If the removing is success, the LED will blink slowly. If the LED is still solid,please repeat the process from step 2
Factory reset Home Energy Meter Gen5
1. Make sure the HEM G5 has been connected to the power supply.
2. Press and hold the Action Button for 10 seconds.
3. If the LED starts slow blinking, which indicates the reset is success, otherwise please repeat the process from step 2
Please note that this is a user manual Home Energy Meter Gen5 from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Home Energy Meter Gen5 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.