The following is an overview of the user manual for the Z-Wave product illumino Dimmer Switch (ZWA037-A)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.
Overview
illumino Dimmer Switch is also a security Z-Wave Plus™ device and supports Over The Air (OTA) feature for the products firmware upgrade.
Security
As a Z-Wave Plus certified product, illumino Dimmer Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Aeotec describes illumino Dimmer Switch as having the following features:
- Switch Load Capacity Watts
- Neutral Wire Required
- Z-Wave Scene Type
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Volt-Ampere
- Switch Type
- Color
- Switch Load Capacity Current
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Turn the primary controller/ gateway into adding mode.
2. 1x tap the Top/ Bottom button of Dimmer Switch.
1. Turn the primary controller/ gateway into removing mode.
2. 3x tap the Top/ Bottom button of Dimmer Switch .
SmartStart location
SmartStart QR code's location as follows: Page 2 and 10 in the user manual.
Factory reset illumino Dimmer Switch
Press and hold the Top/ Bottom button for 20 seconds.
Please note that this is a user manual illumino Dimmer Switch from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have illumino Dimmer Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.