The following is an overview of the user manual for the Z-Wave product illumino Wall Switch (ZWA038-A)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.
Overview
It can connect to external manual switches to control the load ON/OFF independently.
The illumino Wall Switch is also a security Z-Wave Plus™ device and supports Over The Air (OTA) feature for the products firmware upgrade.
Security
As a Z-Wave Plus certified product, illumino Wall Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Aeotec describes illumino Wall Switch as having the following features:
- Color
- Switch Load Capacity Watts
- Switch Load Capacity Current
- Switch Type
- Z-Wave Scene Type
- Firmware updatable via a compatible Z-Wave gateway
- Neutral Wire Required
- Electric Load Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Page 2 and 9 in the User manual.
1. Turn your primary controller into inclusion mode.
2. Press the Top/Buttom button once on product.
1. Turn your primary controller into exclusion mode.
2. 3*tap the Top/Buttom button on product.
Factory reset illumino Wall Switch
Press and hold the Top/ Bottom button for 20s.
Please note that this is a user manual illumino Wall Switch from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have illumino Wall Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.