Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

illumino WallMote 7 (ZWA022-A) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product illumino WallMote 7 (ZWA022-A)from Aeotec. To view other Z-Wave products and manuals from Aeotec follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
illumino WallMote 7
SKU Code
ZWA022-A
Description
Aeotec WallMote 7 is an intelligent Z-Wave™ remote/ scene controller that can be mounted on a wallbox. It has 2 push buttons that you can easily control the Z-Wave devices in your home network via tapping, long pressing the buttons.
It has a RGB LED to indicate the button actions.
The WallMote 7 is also a security Z-Wave Plus™ device and supports Over The Air (OTA) feature for the products firmware upgrade.
Version #
HW: 1 FW: 1.04 was the version certified
Certification #
ZC12-21080284
Certified
2021-08-04T10:47:58.516788
Z-Wave Version
7.13.9

Security

As a Z-Wave Plus certified product, illumino WallMote 7 supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Authenticated
  • S2 Unauthenticated

Features

Aeotec describes illumino WallMote 7 as having the following features:

  • Battery Quantity
  • Z-Wave Scene Type
  • Battery powered using CR2032 batteries
  • Firmware updatable via a compatible Z-Wave gateway
  • Color
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

SmartStart location

SmartStart QR code's location as follows: 1. Page 5 in the Engineering Spec manual.
2. Page 5 in the user manual.

1. Turn your Z-Wave gateway/ controller into adding mode.
2. Tap once the top/ bottom button, then the device will enter pairing mode.

1. Turn your Z-Wave gateway/ controller into removing mode.
2. Tap 6 times the top/ bottom button, then the device will enter unpairing mode.

Factory reset illumino WallMote 7

Press and hold the top/buttom button for 20s

7x tap the top/buttom button.

Please note that this is a user manual illumino WallMote 7 from Aeotec is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have illumino WallMote 7 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.